Technical FAQs

Ask a Question

Can a third party photo cell be used with the light sensitive switches?
No, the light sensitive switches, such as the IC100, IC2000, IC2000P+ and IC100k, are designed to be used with the photo cells supplied with them.
In Spacial.pro, can I add components on the sides of my equipment?
Spacial.pro does not manage installation of the components on the sides of the enclosure. However you can add the parts that you select in the "Other...
How can I use preset speeds on an ATV11?
    It is always advisable before programming a drive to do a “Factory Reset”   go to FUN menu and down to FCS press enter then down to InI press...
What is the ohmic tripping value of a PTC probe on an ATV58?
The motor temperature is detected by PTC probes connected to the ATV58 drive via specific inputs (+10, AI3A, AI3B and COM) on extension card VW3A58201....
How can Schneider Electric Soft Starts be used to run three phase motors in both direction(Forwards and Reverse)
   Soft Starters can not reverse the direction of the motor. To achieve reversal of the motor’s direction a set of reversing contactors must be wired...
What are the degrees of protection (IP) of the Harmony XB4 and XB5 control and signaling units?
The pushbuttons and LEDs are IP66  The selector switches are IP69K.  The IP rating can be improved by adding covers, which increases the protection...
What are the part numbers of the replacement contact sets for LC1F power contactors?
Spare parts required for each pole of LC1Fxx contactors are as follows:   2 fixed contacts 1 moving contact 2 deflectors 1 backplate Locking screws...
What is the pin-out of the RJ45 socket of an ATV31 / 312 for connection of Modbus, CanOpen and PowerSuite cables
     The RJ45 socket of the ATV31/312 can be used for connection to the following networks and accessories:      a PLC via a Modbus bus or via a CANopen...
How do you calculate the size of the enclosure required for the ATS48’s to dissipate the heat generated
          To calculate the size of the enclosure required for an ATS48 soft start you would use the follow equations                          To calculate...
Must I use the CMD Tool software proposed by Phoenix Contact to configure the M1 PLC Interbus network?
To configure devices on the Interbus IOBUS network for M1 PLCs it is preferable to use Modsoft 2.61 or Concept 2.2 SR2. Caution: Access to the M1...
Results 51 - 60 of 100