Technical FAQs

Ask a Question

Filter results

Clear
Video: How can the type of stop be changed for the ATV312 (or ATV31) drive?
Issue: Need to change the Stop Type on the ATV312 drive. Product line: ATV312, Altivar 312, ATV31 Resolution: The default setting for Type of Stop...
What is a good source of information for the ATS48 soft start?
Issue: Information is needed to facilitate installation and programming. Product line: Altistart ATS48 Environment: All models, all serial numbers...
How is a run permissive function added to an ATV61/71?
Issue: How is a run permissive function added to an ATV61/71? Product Line: Altivar 61 71 ATV61 ATV71 Environment: All models Cause: The VFD needs...
How to setup a Fault Status on the Altivar Process Drive?
Issue: How to setup a Fault Relay on the Altivar Process Drive? Product Line: Altivar Process Drive (ATV630, ATV930, ATV650, ATV950, ATV660, ATV960,...
What causes a CONE fault code on an ATS22 softstart?
Issue: What causes a CONE fault code on an ATS22 softstart.  Product Line: ATS22, Altistart 22 Environment: All Cause: N/A Resolution:  This is caused...
Downloading Realflo Configuration Produces 'Liquid Calculation was unsuccessful' Error Message
Problem: When trying to setup a Flow Run with Realflo v6.91.2 to perform Liquid Calculations, RealFlo doesn't report any errors with the entered parameters....
How to use accutech AI10 device to measure levels or pressures?
Configuring the Sensor Offset Curve for a field unit using Accutech Manager software. In order to create an accurate offset curve you will need to...
On an ATS22 soft starter, what does PIF fault indicate?
Issue:  On an ATS22 soft starter, what does PIF fault indicate? Product Line: ATS22  Environment: All models Cause: ATS22 faults on PIF. Resolution:...
What is the maximum earth fault loop impedance Zs for the Tesys GV7? What values are taken into consideration to calculate the Zs values?
The charts below detail the Earth Loop impedance (Zs) for the GV7 range for any TN system based on the British Standard BS7671:2008+A3:2015 Two documents...
What’s the Earth loop impedance value Zs for the GV3 range?
The charts below detail the Earth Loop impedance (Zs) for the GV3 range for any TN system based on the British Standard BS7671:2008+A3:2015 Two documents...
Results 1 - 10 of 100