Technical FAQs

Ask a Question

Filter results

Clear
Is the NSX maintenance case TRV00911 compatible with Windows 8?
The maintenance module is compatible with windows XP and 7 for which no digital signature is requested.  Windows 8 will simply refuse the installation...
How to connect XPSMC via USB, using TSXCUSB485 USB converter?
XPSMC + TSXCUSB485 hardware connection XPSMC + TSXCUSB485 software rules
Are the MGFS Fuse Switch Disconnectors and the MGFD Switch Disconnectors suitable for use on DC systems?
The MGFS Fuse Switch Disconnectors and the MGFD Switch Disconnectors are only suitable for use on AC systems. The utilisation categories are: AC20A,...
Can I use an undervoltage release (MN type) for C60 on a 60 Hz system.
Yes, the MN undervoltage release for C60 circuit-breakers can be used on a 60 Hz system. The C60 range is now obsolete. The current range, the Acti9...
Is TwidoSuite or Twido Soft software compatible with Windows 7?
Twido Soft software will never be compatible with Windows 7 as this software is obsolete. However, TwidoSuite version 2.31.4 is compatible with Windows...
Will Vijeo Designer work on Windows 7 64 bit?
The compatibilty depends on the version and Service Pack of Vijeo Designer. The table below gives some information   Version and Service Pack Windows...
Is Zelio Soft 2 software compatible with Windows Vista and/or Windows 7, Windows 8 and Windows 10?
Zeliosoft 2 V5.0,  is compatible with the following: Windows 7 32bit Windows 7 64bit Windows 8.1 32bit Windows 8.1 64bit Windows 10 32bit Windows...
How long does it take the digital input for logic discrimination (ZSI) to be recognized by the Sepam relay and setting group A to be
It takes about 13 ms (one cycle time of the control reading) operating time for the relay to recognize and react to an input change. Note: For a Sepam...
What is the difference between a VPIS and a VDS (SM6, RM6 power ON pilot light)?
VPIS (Voltage Presence Indicator System): According to standard IEC 61958 the purpose of a VPIS is to signal a voltage presence. If a lamp is unlit,...
Question Why does the Sepam Series 20, 40 and 80 Relay not display waveforms for all phases of current / voltage?
When certain variables are calculated rather than acquired (measured) by Sepam, the waveform associated to those variables is not available. Those...
Results 1 - 10 of 68