Narrow By
  1. Your SelectionRemove All

Settings - FAQs

FAQ Search
Most Recently Published FAQs

Results 31 - 40 of 100

FAQ ID Description
FA22881Can I control a motor with a rating lower than that of the variable speed drive?
  Yes it is possible to use a motor with a lower rating than that of the drive. For instance If  you are trying to test a system with either a very...
FA24892How can I distinguish thermal from magnetic faults when using GV2ME, GV2P, GV2L and GV2LE?
Using a GVAM11 combined with a GVAD10xx, it is possible to distinguish between thermal and and magnetic faults.   If there is no fault:  GVAM11:...
FA28044What adaptation parts satisfy standard UL 508 type E on the GV2P and GV3P?
The adaptation parts to be used so that GV2P and GV3P circuit breakers comply with standard UL 508 type E are detailed below. For GV2P circuit breakers: ...
FA24950How can I connect an external braking resistor to a Lexium 05?
The Lexium 05 range of drives have an internal braking resistor included in the drive. The internal braking resistor is connected as standard when...
FA132584What is the maximum earth loop Impedance value for the P25M miniature circuit breaker
The maximum earth loop Impedance figures can be found on the attached pdf file.
FA132683How is the ICMP Ping utility setup in ConneXview?
The ICMP ping control inside of ConneXview has 2 components, one component for discovery of network nodes and another that monitors the node. See...
FA133023Does LT3 thermistor relay need to reset after a power failure?
After a power failure the LT3SM does not need reset ( unless the thermistor conditions have taken the unit to a fault condition )
FA133108My Phaseo ABL1 Power supply is not giving 24V what can I do?
The Phaseo ABL1 range of power supplies have a voltage adjustment potentiometer screw.  The adjustment potentiometer is located by the terminal strip. The...
FA133263Can I remote reset an LR97D electronic overload?
Yes, if the power supply to the unit is briefly interrupted for a period greater than 0.1 second the unit will reset. Below is an illustration from...
FA133181How do I use an LR97D Electronic Over current relay with a single phase motor or load?
To use the LR97D Electronic Over current relay with a single phase motor or load the LR97D unit must be set in single phase operation.  The switch...

Results 31 - 40 of 100